1. Preparation
Jack up the bicycle.
It must be able to rotate the rear wheel and chain by foot pedal.

2. Positioning KETTENMAX
At an easily accessible point, connect upper and lower tank above the chain and secure with O-ring/clip.

3. Securing KETTENMAX
Insert the stabiliser into the respective bores of KETTENMAX and connect with the cross strut.

4. KETTENMAX height
Adjust height of KETTENMAX by spring cotter at the KETTENMAX-stabiliser (straight running of the chain must be ensured).

5. KETTENMAX spacer
Insert spacer into the respective bores of KETTENMAX to support KETTENMAX. When the chain runs through, KETTENMAX is supported by the bracket of the rear derailleur. You can shift gears during cleaning and lubricating; make sure to keep derailleur bracket as vertical as possible during gear shifting (e.g. small pinion gear at the pedal spindle - large pinion at the chain sprocket or vice versa).
Alternative to spacer, hang up with hooks and cord.

7. Lubrication the chain
Spray a controlled dose of lubricant (conventional chain sprays or oils) into the box via the lubrication adapter at the spray nozzle connection (top box on the side of chain run-out) or drop itin via the oil bore of the KETTENMAX.
Turn the pedal at the same time to ensure that the lubricant accurately coats the cain and is evenly distributed by the brushes.
The chain must be dry to ensure optimum adhesion of the lubricant.
Contaminated cleaning solution and any excess lubricant must be drained into a container and appropriately disposed of in an environmentally friendly manner!